Installation & Setup
-
How do I install Spectrum 2in1 LED headlight globes?
Step by step: fit the collar first, match the arrows on the black plugs, power the controller, then test white and colours. Includes HID ballast bypass and the polarity flip. -
How do I install the underglow and interior kits?
Underglow is plug and play to the fuse box or battery. Footwell kits run off USB. The PRO 18in1 ambient kit is hardwired with door sub controllers. Use heatshrink on joins. -
How do I wire the controller box to power?
Red and black wires with fuse add a circuits: use the ignition or parkers fuse position, or clamp straight to the battery. VE and VF Commodore use F37 in the engine bay. -
My lights are not working. Where do I start?
Check the red fuses first, then power, then plug arrows. Colours need headlights off, white on one side means flip the plug, and a dead remote needs a re-sync. -
Our Spectrum 2in1 Globes all use the same "Public" Frequency for the RF Remote. This means any Spectrum RF Remote will work with your lights To set your own Private Frequency to control only your lights simply.. Disconnect from power source (you can remove fuse) then hold "RED" + "3" and connect...
-
Troubleshooting Bluetooth Controller
Holden VE - The Battery is in the Boot so you can connect in engine bay like this Holden VF Colours are not working. Make sure Car Headlights are turned off. Location/GPS must Turned ON and permissions for the app is allowed. Check your arrows on black plugs that they are facing each other. ... -
Try pairing the remote to do this disconnect from power source then hold "RED" + "3" and connect to power source again. it should flash. to clear the pairing hold "Power Button" + "6"
-
Which app do I use and how do I pair it?
Spectrum LED for 2in1 globes and standard kits, Banlanx for PRO headlights and underglow, Zengge for footwell. Connect only inside the app with Bluetooth and Location on.